NuLook Concrete
& Masonry Cleaner is a unique fluid applied cleaner that removes
oil, grease, rust stains, tire marks and more from concrete & masonry
surfaces making it look NEW again without harming the surface.
 
NuLook
is designed to release cleaning agents that emulsify all types of oil,
grease and grime, removes tire marks and various types of rust stains.
After
cleaning the surface the NuLook
formulation causes a whitening effect on the surface treated. This gives the
concrete that "new look". We then recommend sealing the concrete with Trojan
Masonry Sealer.
Trojan is a penetrating sealer that creates a life-time bond
filling the
pores and
sealing from within!
Advantages of using NuLook Concrete
Cleaner:
*
User friendly and easy application
* No mixing and water soluble
* Works in 3-5 minutes
* Non-toxic, Non-flammable
* Reduce exposure to toxic chemicals
* Get the job done safely and effectively
* Time and man power savings
Also, should
you not want the whitening effect or you have dark color bricks to clean we recommend
using Easy Brick Cleaner
instead. (Note: always TEST the surface to be treated first !).
If rust
and stains are present, we suggest using
Rust Stain Remover and then apply the
NuLook Concrete Cleaner.
NuLook
has been used successfully to clean the following surfaces:
Concrete Masonry Brass Drains
Pavers Brick
Split face
block Asphalt
Tile Grout
NuLook removes
the following stains:
All types of Oils Grease
Various Rust Stains
Cleans Algae/Mildew & Mold
Cleans grout lines
& tile
Helps eliminate compactor or trash site smell
Even though NuLook is
environmentally safe,
that does not
mean that these products should be taken lightly. When using
NuLook you should always
practice safety precautions by using safety goggles, gloves and boots. Read
all MSDS and Product information that is provided for you.
NuLook is a finished
product and requires no mixing and works in just minutes. Also some stains
will require one or two applications of a fine mist versus saturating the
area with more product. Think of it as removing layers from the pores
therefore using large amounts of the product in not always better.
Based on the surface to be treated one (1) gallon of
NuLook will clean
approximately 300-350 square feet. Should it dry on the surface when
applied, water will reactivate the cleaning process.
For contractors a fast and effective method of getting good results with
this product is to use a RotoBlaster type of deck scrubber that we
also sell. We have found that using 25 degree tips and a minimum 3000 psi
power wash will get
the optimum
results. Also application of this product can be done with a
Chapin 1035 pump sprayer, an all plastic model that comes in 1.5, 2 and 3
gallon models.
 
|